Logitech Harmony 650 Universal Remote Control Codes and Program Instruction

Last Updated on October 17, 2022 by Randall

You may easily add codes to your Logitech remote using the remote control program from this Logitech if you can get the software from the Logitech official website. In essence, platinum and also Logitech work together to generate these codes. The only thing you have to do is go to “setup.myharmony.com” and configure your remote using the database. Simple!

See the information below if you want more advice on the Logitech Harmony 650 universal remote code.

Remote codes for Logitech Harmony Remote control

Digits	Remote Codes
Five-digit codes	53272
Four-digit codes	2639327275037340

How To Setup Logitech Harmony 650 Remote

Your harmony remote may be set up in a few easy steps so that you can use it right away. Following the procedures below, you will have control over the remote.

selecting “Add Device”
then choose “satellite” from the “Devices” section.
Select “beyond platinum,” which is located under “manufacturer,” after that.
In the “Model” field, type “Explora MODE1” or “Explora MODE2” to finish.
The remote may be tested right now, and it is functional.

How to Program Logitech Harmony 650 Universal Remote With Auto-Search

Turn on the smart device you want to use the universal remote to control, such as the TV.
To “turn on” a device, press and hold the TV, DVD, CBL, and OK/SEL buttons for three seconds. The device is prepared to program, according to the LED light.
Use the remote to select the “CH+” and “CH-” switches. On/off indications are displayed on the remote. Continuously press the “up” or “down” key until the device turns off.
Click the “power” key to confirm the code. It should start up. If it does, try a different channel to make sure the remote is configured properly.
To store the code, press the “device” button now. The device’s LED will flash twice to verify the code that was stored.

How to Program Logitech Harmony 650 Universal Remote With Manual Method

You must first “Turn The Device On.”
On your “Logitech Harmony 650 universal remote,” select “TV.”
In order to put the universal remote in “learning mode,” press and hold the “Setup button” until it flashes a light.
At last, key in the “Keycode” you gathered from the programming manual (Instructions Booklet)
Simply “aim your remote at the TV” after completing this step, and then “Press and Hold The Power” button.
When the screen dims, you can release the “Power Button.”

Final Words

Please get in touch with us if you need help with any universal remote codes; we’ll be happy to offer a better solution and take care of your problem as soon as we can. Visit us frequently to acquire updated universal remote codes.